Category: PROJECT
-
2019.06.04(pm): Laser cutting the body plate to be modified and adjust legs
Two points on the Jansen bridge must be fixed to the motor and other fixed axes. Therefore, the part is unstable when connecting joints with bamboo sticks. Only that part was fastened with iron shaft and M4 bolt.
-
2019.06.04(am): Modify the design to change the shaft
I reduced the length of the street from 200 to 190 and reduced the length from 160 to 150. 2019 06 04 strandbeest body plate to be modified dxf file
-
2019.06.02(am): 18650 Battery pack capacity test for operating 4 worm-geared dc motor
To test the capacity of the 18650 battery pack (11.1V, 3S, 7800mAh) made yesterday, I set the recording environment and turned the camera. However, the webcam camera takes a video for a maximum of 3 hours, so there is only 3 hours of video. I only found out that it worked for three hours. So,…
-
2019.06.01(pm): How to make 18560 Li-ion battery pack(11.1V, 3S, 7800mAh)
Insert battery into holder Capon tape winding Welding on nickel plate Soldering the protection circuit Put in shrink film
-
2019.06.01(am): How to format a Ubuntu PC and install a new Ubuntu OS
I made USB for the Ubuntu OS. To format a PC that already has Ubuntu installed, you must first change the boot options. After turning on the PC, press F2 to enter the BIOS screen. Enter the boot sequence, change the boot order to USB storage Decive first, select UEFI in the Boot List Option,…
-
2019.05.31(pm): How to make booting disk in USB for installing Ubuntu desktop OS
At first, you need to make booting disk in your USB. You can download the Ubuntu OS for desktop in this link below https://www.ubuntu.com/download/desktop And, you can also download the Universal USB Installer
-
2019.05.31(am): How to connect 18650 battery pack with protect circuit
18650 Li-ion battery The 18650 lithium-ion battery is 3.7V per battery, 4.2V when fully charged. Unlike an alkaline battery, a lithium ion battery can be used as a rechargeable battery and has a large battery capacity. But be careful of the impact. There is a risk of fire if the battery is stung or shocked…
-
2019.05.30(pm): Let’s make a leg mount again to complement the 4-legged robot.
2019 05 30 3d printing test g code file for stainless steel legs
-
2019.05.22(pm): strandbeest 4th version 3D modeling with Rhino
Design Process download file below 2019 05 22 strandbeest 4th version 3D modeling with Rhino
-
2019.05.21(pm): How do I change the height of a sketch in Rhino?
After drawing the picture to make the strandbeest’s body plate, I came back to fix it later, and I had to reverse what I had done to lower the height to extude the hole previously to make the column shape. In this case, it is easiest to select all the holes and then press GumballTransform…